Ion-science Hydrosteel 7000 User Manual download pdf (Page 21)

Hydrosteel 7000 MANUAL Ion Science Ltd

Page 21 of 43

Unrivalled Detection. www.ionscience.com

Installation

 Conduit and tails do not rest against hot piping or equipment. As they contain thermoplastic

components that may be damaged.

WARNING!

Sample Conduit and tails must not be exposed to elevated temperatures above 100 C. These temperatures

can easily be experienced if the conduit or tails are in surface contact with high temperature process pipes.

Connection of probes to sample conduit

Remove the probe caps. Simply attach the AT-S and ambient gas probes manually using the threaded

unions provided. Ensure that the correct capillaries are attached to the correct conduit cable

 Tube with nut marked F (red tube or red cable tie) to AT-S probe

 Tube with nut marked B (white tube or white cable tie) to

background probe.

 Tighten the conduit nuts securely (1/8 turn) using 11mm

spanners.

 Use cable ties through the slots in the probe bracket to hold

the probe connections in place.

Connection of thermocouple cables

The thermocouple lead terminates in two wires; these must be connected to the thermocouple cable in the

conduit at the thermocouple junction box. To maintain the continuity of the thermocouple screen, EMC

cables glands supplied must be used. Clamp the thermocouple pot into the cable gland. The internal

conductive spring tabs will make electrical contact with the thermocouple sheath and the pot will be

mechanically secured when the seal is compressed tight. Please see photographs below that follow.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 42 43

No comments

Ion-science Hydrosteel 7000 User Manual Page 21